Similar in use as the example above for Swivel Knuckles with three regular knuckles and tubing to fit your needs. Ready for use for low platforms or for mounting lights.

Used for clamping camera car bridge plates to the tubes. Requires a 1/2" slot thru the bridge plate for the hold down bolt. Cast aluminum with forged swing bolt and aluminum lock knob. Set of 2.

A bridge plate is used to mount the camera leveling head & camera Custom built to your required length and width. We now offer the "Hollywood" style bridge plate which is made up of two 1/4" (6 mm) aluminum plates welded on top and bottom of two 1-1/2" (3.8 cm) square tubes. Two widths (front to back) are available, 8-inch (20.3 cm) and 12-inch (30.5 cm). The length is made to fit your requirements. After welding, slots are machined in both the top and bottom plates for fastening to your camera car with bridge plate clamps.

Through machined for extra support on platforms w/ clamp bolts

Swivels 175 degrees like normal swivel knuckles, but in addition it rotates 360 degrees.

Knuckles (as above) but with a swivel shank for drop arms used for low angle shots. Swivels 175 degrees. Note: price is for each knuckle. Two swivel knuckles are shown as an example of typical application.

Custom machined to fit your tubing or pipe. Heat treated aluminum with hardened swing bolt, stainless steel pivot pins, and lock knob.

Machined to fit your tubes w/clamp bolts.