Camera Mounts and Risers

Camera Head Riser

Used on a dolly or crane to increase camera height. Clear anodized finish or special color at additional charge. Includes a Mitchell top plate, a Mitchell bottom threaded shank and bronze lock nut (pictured). A 100 or 150 mm ball top plate can be substituted for the Mitchell top plate. Also available with Euro, or Vinten top plate -- inquire.

Back to Top

Rotating/Swinging Offset

Offset with interchangeable size head plates. Mitchell head plate included. Additional ball head plates available for 100 and 150 mm. Use one offset and change head plates for versatility.

360° rotation in 5° increments. Locks firmly. Top and ratchet plate are clear anodized. Main plate is black anodized. Also available all black (as pictured) or special colors at additional cost. Note: Dimensions are from center-to-center NOT overall length.

Additional ball head plates for 100 mm and 150 mm. We include a set of 3-inch (7.5 cm) posts if you need a riser-type offset.

Back to Top

Locking Rachet Plate

Building a slider? Willy now makes the locking ratchet plate mechanism. It's the same mechanism that is used on our rotating offset, but mounted on a 3/4" thick aluminum plate with a 3/8" mounting hole on each corner, which you can fasten to your slider to provide 360 degree rotation with positive locking every 5 degrees. Mitchell Shank and bronze nut included.

Weight 12 lbs (5.4kg)

Back to Top

Ubangi Offsets

Available with either Mitchell removable shank and lock nut, or Chapman® bolt type. Anodized black or clear. Other colors at additional $25.00 cost.

Three hole Ubangi, Mitchell shank shown.

Back to Top

Car Door Mount (Hostess Tray)
— Special Order Item —

Used for filming from the side door of a camera car. Also for side-raking shots to front or rear of car. Mount can be positioned for low-angle tire shots. Aluminum 14" x 20" (355 mm x 508 mm) mount plate has 3/8" (10 mm) holes. Zinc plated. Top plate is black anodized. Comes complete with straps. Ball camera mount is not included; order separately.

Back to Top

Car Hood Mount
— Special Order Item —

Used for shooting back towards driver or for front looking P.O.V. shots. Can also be mounted on top of car, on front of trucks, etc. Once mounted, the camera mount can slide from side to side simply by loosening two knobs. Side mounts adjust to clear hood or to raise camera. Mount camera directly on the supplied plate, or on our ball head or low 4-way head. Includes 4 straps and instructions.

Back to Top

Willy Grip - 45 Degree Suction Cup Grips

Close out special on remaining stock - $295.00

Mounted on a 10" (254 mm) suction cup. While we don't recommend using them to mount cameras on cars for moving shots, they are useful for lights and to mount lights on windows in offices and the like. This model tilts 45 degrees each direction of horizontal. Case included.

Weight 10 lbs. (4.5 kg)

Back to Top

Suction Cup Thingy

Use for small lights, as a fastener for grip heads on a car... whatever! 6-¹/₂" (165 mm) suction cup with ⁵/₈" baby pin attached. Supports 50 lbs. (22.7 kg).

Back to Top